If you use a DStv Explora or HD decoder with multiple viewing outputs, you can control your second TV using the same remote. Switching your DStv remote to TV2 mode allows you to manage the second television connected through a TV Link or ExtraView setup without affecting the main TV. The process is simple and requires only a few button combinations on your remote.
Understand TV1 and TV2 Modes
DStv remotes are programmed with two control modes — TV1 and TV2.
- TV1 Mode: Controls the main decoder connected to your primary TV.
- TV2 Mode: Controls the second TV, usually connected via RF cable or TV Link from the decoder’s RF output.
By changing to TV2 mode, your remote only communicates with the secondary setup, preventing interference with the main decoder in another room.
Check Your Decoder Type
Before making any changes, confirm that your decoder model supports this function. Most DStv Explora, HD decoders, and Dual View decoders include TV1 and TV2 capabilities.
If your setup uses ExtraView or a TV Link connection to a secondary television, your remote can easily be programmed to control TV2.
Point the Remote Away from the Decoder
When changing the remote’s mode, point it away from the decoder. This ensures that the remote does not send commands to the decoder during setup and only updates its control mode.
Change the Remote to TV2 Mode
Follow these steps to change DStv remote to TV2 mode:
- Press and hold the TV and Power buttons together.
- Wait for the LED light on the remote to flash once and stay on.
- Press the 2 button on the number pad.
- Press the OK button.
- The LED light will flash again, confirming the remote is now set to TV2 mode.
Test the Remote on the Second TV
Move to your second TV and test the remote. Try using the Power, Volume, or Channel buttons.
- If the commands work, your remote is correctly configured to TV2 mode.
- If not, repeat the steps carefully and ensure your TV Link connection is properly set up.
Changing Back to TV1 Mode
If you want to revert your DStv remote back to the main decoder (TV1), follow the same steps but press 1 instead of 2 in step four.
To switch back to TV1 mode:
- Hold TV and Power until the LED lights up.
- Press 1, then OK.
- The LED will flash to confirm the remote is back in TV1 mode.
Troubleshooting Tips
If your remote doesn’t respond after switching to TV2 mode:
- Check that the TV Link cable is properly connected from the decoder to the second TV.
- Ensure the TV Link LED is on.
- Replace the remote batteries if they are weak.
By following these easy steps to change DStv remote to TV2 mode, you can enjoy seamless control over both televisions in your home without interference — perfect for ExtraView setups and dual-room viewing.
